Operation; Basic Operation - AccuBANKER Multi-Scanix D585 Guia Del Usuario

3. Operation

3.1 Basic Operation

1. Connect the power cable to the detector and then connect the adapter to the power
outlet. After turning on the detector, the equipment will begin a self-check process
that lasts about 5 seconds. The display will read 0, which means that the equipment is
ready to check the bills. If there is any error code, refer to the Error Messages section
of this user guide on page 18.
2. Select the type of currency to be verified (USD-EUR-GBP) by pressing the
CURRENCY button.
3. Insert the bill to be checked into the feeding channel (insert in any direction). When a
bill is presented at the feeding channel, an optical sensor located in the this compartment
allows the detector to automatically begin the verification process. The bill will pass
through the equipment and be analyzed immediately.
4. The detector will verify the bill and show the denomination as confirmation that it is
genuine. Its value will be added to the verified total.
5. If a bill is suspicious, it will be rejected and there will be two audible warnings. Its
value will not be added to the current verified total. The error code corresponding to the
suspect security parameter will appear on the screen as well as the word "FAILED". The
suspicious bill will then be rejected forward (even if the bill exit direction has been set
to exit through the back of the equipment).
10