Configuration - Festo VIFB13 Serie Manual De Usario

VIFB13 - 03/05
2

Configuration

PLEASE NOTE
The cover is connected to the internal PC boards via the
operating voltage cable. It cannot therefore be removed
completely.
CAUTION
The components of the valve terminal contain elements
which are liable to damage by electrostatic charges. The
components can also be destroyed if the contact surfaces of
plug connectors are touched, or if the regulations for hand-
ling electrostatically vulnerable components are not observed.
Please observe the following when configuring:
1. Switch off the operating voltage.
2. Open node (screws are liable to be lost).
3. Set fieldbus address.
4. Activate voltage monitoring, if desired.
5. Close node.
6. If the valve terminal to be connected is at the end of the
PROFIBUS, the terminating resisitor in the Festo Sub-D plug
(part no. 18529) must be activated.
12
9809b