Tabla de contenido
Idiomas disponibles
Idiomas disponibles
III. DARK SHADER SELECTION
•
Select the shade level according to the welding process and the value
of the welding current by turning the potentiometer knob on the left side
of the helmet
•
The shade number can be between DIN9 to DIN13. Select a shade
number by turning the shade knob until the arrow points to the required
setting (See Shade Guide Table)
•
ALWAYS use suggested shade numbers instead of minimum shades.
•
Provide additional task lighting that suits welders' needs.
•
ALWAYS use the same shade as the welder's if you are directly
observing the welding arc.
Shade numbers are given as a guide only and may be varied to suit individual needs.
Process
Shielded Metal Are
Welding (SMAW)
Gas Metal Arc
Welding (GMAW)
and Flux Cored Arc
Welding (FCAW)
Gas Tungsten Arc
Welding (GTAW)
Air Carbon Arc
Cutting (CAC-A)
Plasma Arc Welding
(PAW)
Plasma Arc Cutting
(PAC)
*As a rule of thumb, start with a shade that is too dark to see the weld zone. Then go to a lighter shade which gives sufficient
view of the weld zone without going below the minimum.
IV. SENSITIVITY SELECTION
•
You can, according your operational conditions, select suitable grade
(low or high) to meet your requirements of the TIG welder or other small
electric ARC welders (can choose high sensitivity).
LENS SHADE SELECTOR
Electrode Size in.
(mm)
Less than 3/32 (2.4)
3/32-5/32 (2.4-4.0)
5/32-1/4 (4.0-6.4)
More than ¼ (6.4)
Arc Current
(Amperes)
Less than 60
60-160
160-250
250-550
Less than 60
60-160
160-250
250-550
Less than 50
50-100
150-500
Less than 500
500-1000
Less than 20
20-100
100-400
400-800
Less than 20
20-40
40-60
60-80
80-300
300-400
400-800
(available on the model ST-1S only)
1-3
Minimum
Suggested*
Protective
Shade No.
Shade
(Comfort)
7
-
8
10
10
12
11
14
7
-
10
11
10
12
10
14
8
8
10
10
11
6
6 to 8
8
10
11
4
5
6
8
8
9
10
10
12
14
12
14
10
12
14
4
5
6
8
9
12
14
Tabla de contenido
