Sensor Activation - Cherubini A520012 Manual De Instrucciones

Ocultar thumbs Ver también para A520012:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

Before assembling the shell on the base:
- Rotate the selector to a middle value from 1
to 9 (e.g. 5).
- Activate the sensor by pressing the SET
button for at least 4 seconds until the LED
flashes twice quickly.
"STATIC LOAD" FUNCTION ACTIVATION/DEACTIVATION
You have 10 seconds to check and change the function status as required.
LED OFF = function not active
LED ON = function active
To change the function status, press the SET button briefly.
To change the previously memorised
angle of inclination, the function must
be deactivated and then reactivated as
follows: LED ON - OFF - ON.
4
PROCEDURE WITHOUT ACTIVATION "STATIC LOAD" FUNCTION (LED OFF)
- Snap the shell onto the base.
- Stand by for 10 seconds until the sensor detects the rest position and the motor makes
its confirmation movements*.
Within three minutes proceed with the SENSOR TEST OPERATION.
4
PROCEDURE WITH ACTIVATION "STATIC LOAD" FUNCTION (LED ON)
- Snap the shell onto the base.
- Stand by for 10 seconds until the sensor detects the rest position and the motor makes
its confirmation movements*.

SENSOR ACTIVATION

10 sec.
........
10 sec.
........
5
set
SELECTOR
4 sec
set
*Note:
*
manufactured before 01/2013 and
TDS Gold control units manufactured
before 04/2013 the procedure ends
without confirmation movements.
*Note:
*
manufactured before 01/2013 and
TDS Gold control units manufactured
before 04/2013 the procedure ends
without confirmation movements.
20
set
for
Wave
RX
motors
for
Wave
RX
motors
Tabla de contenido
loading

Tabla de contenido