Kobalt SGY-AIR134TZ Manual Del Usario página 12

ASSEMBLY INSTRUCTIONS
4. If necessary for a longer reach, mount an
extension bar (not provided) onto the anvil until
it clicks into place, then mount the socket on the
adapter as shown in Fig. 4.
5. Place 2 – 3 drops of air tool oil (not included)
into the male air plug before each use, as shown
in Fig. 5.
NOTE Proper lubrication is EXTREMELY important
to assure proper tool performance and avoid tool
damage. ALWAYS lubricate the tool before each
use if not using an in-line oiler.
Make sure compressor air supply hose has correct
fittings installed at each end: male coupler goes to
compressor, 1/4 in. female coupler matches up to
1/4 in. male plug installed on the tool.
6. Connect the air supply hose to the male air plug
as shown in Fig. 6, making sure it is completely
seated and secure. Set the working pressure at
90 PSI for best tool performance.
NOTE To operate correctly, this tool requires
airflow of at least 7.0 cubic feet per minute (CFM)
at 90 pounds per square inch (PSI) at the tool.
4
5
6
12