Tabla de contenido
Idiomas disponibles
Idiomas disponibles
III.
MAINTENANCE
To prevent ignition of hazardous atmospheres, disconnect the fixture from the
supply circuit before opening.
High voltages are present inside the light assembly. Wait at least 5 minutes
after disconnecting the power before servicing this unit.
Listed below are some important safety instructions and precautions you should
follow:
•
Read and understand all instructions before operating this system.
•
Any maintenance to the light system must be done with power turned off.
•
Any maintenance to the light system must be performed by a trained electri-
cian who is thoroughly familiar with all applicable national and local codes in
the country of use.
•
Never alter the unit in any manner. Safety of the unit may be affected if ad-
ditional openings or other alterations are made to the internal components or
housing.
•
The nameplate should NOT be obscured, as it contains cautionary and/or
other information of importance to maintenance personnel. Ensure the name-
plate remains readable if the housing exterior is painted.
•
If the dome is damaged in any way, it MUST be replaced.
•
After performing any maintenance, test the light system to ensure that it is
operating properly.
Failure to follow all safety precautions and instructions may result in property
damage, serious injury, or death to you or others.
To maintain the vapor-tight enclosure, do not damage the globe or threads
while disassembling or reassembling the unit. Lubricated threaded joints
exposed for long periods of time may attract small particles of dirt or other
foreign materials. Housing and cover joints should be reassembled immedi-
ately, with all the threads fully engaged.
A.
Changing units from flashing mode to steady mode.
1.
Disconnect power to the device before beginning.
2.
Remove the threaded dome assembly by twisting it counter-clockwise. See
Figure 1 on page 8.
SAFETY MESSAGE TO MAINTENANCE PERSONNEL
-4-
Tabla de contenido
