Accessories; Installation Site Choosing - Carrier 42QHP09E8S Serie Manual De Instalación

1. PREPARING FOR INSTALLATION

1.2 ACCESSORIES

The following accessories are supplied with the unit. The type and quantity may differ
depending on the specifications.
Shape
Name of Accessories Q'ty(pc)
Manual 3
1
Drain outlet
1
Gasket
1
Installation plate
Anchor 5
Screw A 5
* means that according to the actual quantity.

1.3 INSTALLATION SITE CHOOSING

Indoor Unit
- A location which can bear the weight of indoor unit.
- Do not install indoor units near a direct source of heat such as direct sunlight or
a heating appliance.
- A location which provides appropriate clearances as below figure.
- Moving parts of appliance must be installed/located at the level not less than 2.3m from
the floor.
Outdoor Unit
- A location which is convenient to installation and not exposed to strong wind. If unit is
exposed to strong winds it is recommended that a wind baffle be used.
- A location which can bear the weight of outdoor unit and where the outdoor unit can be
mounted in a level position.
- A location which provides appropriate clearances as below figure.
Do not install the indoor or outdoor units in a location with special environmental
conditions.
Confirm that there is enough room for installation and maintenance.
05
Name of Accessories Q'ty(pc) Shape
Remote controller 1
2
Battery
Remote controller holder
1
Screw B
2
Small Filter 1
Magnetic ring N*
(Some units)
1. PREPARING FOR INSTALLATION
Note: Ensure the spaces indicated by arrows from the wall, ceiling, fence or other obstacles.
Piping is possible in the rear, left, left rear and right direction.
Plug the unused
drain hole with the
rubber plug
provided.
Cut the knock-out
panel according to
the piping size.
knock-out panel
06