Troubleshooting; Helpful Hints - Ambiano EP1069T-UL Manual Del Usuario

Troubleshooting

Problem
ADD WATER light
comes on
ICEFULL light
comes on
ADD WATER & ICE
FULL lights turn
on simultaneously
Ice sticks together
Ice making cycle
seems normal but
no ice is being
produced
Poor ice making
result

Helpful Hints


It is recommended to use purified water for clearer cubes.

If a power failure occurs, the power cord is disconnected, or the ON/OFF
button is pressed during an ice making cycle, small chips may form and lodge
in the automatic shovel causing it to jam. UNPLUG the unit and gently push
the shovel to the rear of the cabinet and gently remove the ice chips. Plug
the unit in and press ON/OFF twice to re-start the cycle.

Make sure the ice tray is sitting properly in the unit or the ice shovel will not
be able to deposit the ice cubes.
Possible cause
1. Low or no water
2. Screen at bottom of
reservoir blocked
3. Pump malfunction
1. Ice tray is full
2. Infrared light not
working
1. Ice tray not in the right
position or may be
blocked by an ice cube
1. Water in resevoir is too
low of a temperature
1. Ambient temperature or
water temperature is
too high
2. Refrigerating system
leaks
3. Refrigerating system
blocked
1. Poor heat dissipation
2. Ambient temperature or
water temperature is
too high
Solution
1. Refill water and press ON/OFF
twice to restart cycle
2. Follow cleaning instructions
3. Contact customer service
1. Empty ice tray
2. A. Wipe out the anything that
might be blocking the infrared
light and restart ice maker.
B. Call customer service
1. Make sure ice tray is not being
blocked
2. Unplug the ice maker, plug back
in and restart
1. Stop making ice and restart ice
making cycle after ice melts and
add higher temperature water
1. Restart ice making cycle in an
environment with higher
ambient temperature and fill
reservoir with cold water
2. Call customer service
3. Call customer service
1. Leave 8in clearance on all sides
for proper ventilation
2. Restart ice making cycle in an
environment with higher
ambient temperature and fill
reservoir with cold water
Troubleshooting
11