Operation - Klarstein 10032867 Manual Del Usuario

OPERATION

Power control switch
Control switches for the heating elements are located on the right hand side of the heater
body.
1. The heater has two switches marked "I" or "II". 'I' switch has 600 W output and 'II'
switch has 900 W output.
2. When both the switches are turned ON the heater will run at high heat setting
1500 W.
Temperatureinstellung über den Thermostat
The rotary knob is to regulate the heat in order To maintam a desired temperature.
If the room temperature setting is lower than the temperature setting on the knob the
heater will function and heat up the room until the desired temperature is attained.
If the ambient temperature reaches the set temperature, the heater will be turned off
automatically. Turn the knob further clockwise for higher heat setting.
Operation
1. Set the power control switch to OFF position.
2. Plug the heater into a 10 A wall socket.
3. Set the power switches as per the heat output desired, 600 W, 900 W or 1500 W.
4. Turn the thermostat control knob clockwise until the heater is ON. The power on light
is on. The front of the heater body will illuminate. Slowly turn the thermostat control
knob anti-clockwise until the heater shuts 0FF. The heater wilI automatically maintain
this temperature. For a lower temperature turn the knob further anti-clockwise. For
a higher temperature turn knob clockwise. When you want relocate the heater give
ample time for the heater to cool down.
5. If you want relocate the heater give ample time for the heater to cool down before
you move it.
Caution: Danger of burns
Do not touch in heater when it is in operation. The heater body is hot.
EN
15