Operation - Klarstein SANFORD SMART Manual Del Usuario

OPERATION

1. Switch on the heater by inserting the plug into the socket. The heater starts in
standby mode and shows the WiFi symbol
2. Press the power button
on, the heating symbol
default. This means that the heating is operating in energy-saving mode.
3. Use the Up and Down
Energy-saving mode
have selected the desired mode, the appliance heats in that mode.
4. To set the temperature in one of the modes, press the settings button
until the figures flash. Then adjust the temperature using the Up
buttons. The adjustable temperature range is between 15 and 50 °C.
5. To set the timer, press the settings button
on the display and the figures flash, use the Up
the time. The timer can be set between 1-24 hours. During timer setting, the digits
flash, then the screen returns to heating mode. The timer symbol
display and signals that a timer has been set. The heating runs until the set time has
elapsed.
6. To set the child lock function, press and hold the Up
appears on the display and the control panel is now locked. To disable child lock,
press and hold the Down button. The lock symbol
the child lock is no longer active and all buttons can be used again.
7. To switch off the display light while the unit is in operation, press and hold the
settings button for 3 seconds. Press the button again to turn the display light
back on.
and the temperature set in °C.
to start the heating process. When the heating is switched
and the symbol for energy-saving mode
buttons to switch between the following heating modes:
> High heat output > Antifreeze mode
. When the timer symbol
and Down
light up by
. When you
and wait
and Down
appears
buttons to set
appears on the
button. The lock symbol
disappears and signals that
EN
19