DELTA DORE TYPHONE 2 SV Manual Del Usuario página 18

3
CONNECTION
Before any operation switch off the power supply.
In order to be connected, the product must be separated from its base.
1
2
1
2
The connection to the telephone line can be made by the
"RJ11 plug / RJ11 plug" cable.
OR
On/Off Control
Certain appliances may require an additional relay contactor to be fitted (check amperage
required).
N L
Heat convectors
Please note : The integrated lightning arrester must be earthed (pins 1 and 2) (see technical
specifications).
Please note: Full wiring circuits are not shown in the diagram for reasons of
clarity. Safety devices and other mandatory accessories are not shown.
- The device must be fitted in compliance with UTE C15-100 and state-of-
the-art specifications.
- Appliances connected to or in the vicinity of the device must comply with
EC directive 89/336 on electrical interference.
Flush-mounting box : use the hole in the bottom of the case to
connect the wires.
Wall-mounting :
breakable partition can be
removed to allow
the connection cables to pass.
TYPHONE 2 SV
~
Max. 2A 230 V
Mains supply
1 2
230V
N L
1 2 3 4 5 6 7 8
Switch
E.g. : Control 1
contact closed
=
Heating enabled
- 11 -
1
2
1
2
The RJ11 plug has to be connected on
the side on the product.
The connection to the telephone line
can be made by the RJ11 plug
on the side on the product.
Immersion heater
(hot water supply)
E.g. : Control 2
contact closed
=
Immersion heater enabled
Day/night relay
contactor