Ambiano CM9102TA-UL Manual Del Usuario página 10

9. Use caution while pouring coffee out of pot, as contents will be very hot!
10. Always turn off the coffee maker and disconnect the power supply when not
in use.
Note: The coffee that is brewed will be less than the water added, as some of the
water is absorbed by the coffee grounds. After brewing, allow 2-3 minutes to cool
in between brews.
WARNING: Do not allow children to use the 12 Cup Coffee Maker unless there is
adult supervision. The coffee maker dispenses very hot water!
CAUTION: Never leave an empty coffee pot on a hot warming plate, otherwise the
pot is liable to crack.
Setting the clock and delay brew time
To set the clock:
1. Make sure the coffee maker is plugged in. The clock will flash on the display to
indicate that the time has not been set yet.
2. Press PROGRAM one time, the word "CLOCK" is shown in the top right hand
corner. Continually press the HOUR and then the MINUTE buttons until you
reach the current time.
Note: The time cycle is 12 hours. You must set the clock if you want to use the
delay brew feature.
To set delay brew time:
1. First follow steps 1 through 5 above (how to brew coffee).
2. Press PROGRAM two times, the word "TIMER" is shown in the top left hand
corner. Set the delayed start time by pressing HOUR and MINUTE buttons
until you reach delayed time desired. Then press PROGRAM and DELAY BREW
light will illuminate, meaning delay time is set.
3. After a few seconds, the display will go back to the current time and the
DELAY BREW light will turn on.
4. Cancel delay brew by pressing PROGRAM one time (green light will go off) or
unplugging the coffee maker.
NOTE: You may see the delay brew time in the following ways;
-If the green light is ON, press PROGRAM four times
-If the green light is NOT ON, press PROGRAM two times
10
User instructions