Install The Camera In The Housing - Axis T92E Housing Serie Manual Del Usuario

Page 8

Install the camera in the housing

1. Loosen the bottom cover screws and remove the top cover.
2. Loosen the holder screws and remove the holder.
3. Secure the camera and holder with the screws and washer according to the illustrations and
table below. Tighten the stabilizing screw just lightly and tighten the camera screw to 2 Nm. Be
careful not to overtighten the screws.
Camera model
Example images: AXIS M1114 Network camera and AXIS T92E05 Protective Housing
AXIS P1343 Network camera and AXIS T92E20 Outdoor Housing
AXIS T92E05/AXIS T92E20
Holder position and fasteners
AXIS T92E05/T92E20 User's Guide
AXIS T92E20
I/O cable Cold Startup Delay
No Off (O)
Yes Off (O)
Yes On (I)