Install The Hardware; Prepare The Network Cable - Axis T92E Housing Serie Manual Del Usuario

AXIS T92E05/T92E20 User's Guide

Install the hardware

Prepare the network cable

The provided network cable can be connected in several ways. The first option is to use the cable as
is, with the pre-mounted rubber gasket.
The second option is to use the provided plastic M20 cable gland, which must be used to achieve an
IP66 rating. Using any other cable gland may cause water to seep in and damage the camera.
If a cable other than the provided cable is used, you need to prepare a shielded network cable with
a gasket. Gently force the cable through the gasket provided and attach a network connector. It
may be necessary to pierce a hole in the gasket with the supplied screwdriver.
Notes:
• Do not force the network connector into the gasket.
• Do not pierce the gasket with a knife or other sharp object.
• Always use a shielded network cable (STP) intended for outdoor use between the camera and the end
point and ensure that the end point is properly grounded. Installations of Axis cameras using a
shielded network cable (STP) and a properly grounded end point have been tested to comply with
industry immunity standards' levels such as surge protection. Any other installation method will void
the warranty and leave the unit at a risk.
Page 7