Handwheel, Knobs, Levers; Rails And Fence; Switch Bracket; Wood Extension Table - Powermatic PM3000B Manual De Instrucciones De Operación Y Piezas

3. Tighten both clamps to align front and back
edges of tables. Make sure front edge of wing
remains flush with front edge of saw table.
4. Tighten screws incrementally, and position
straight edge at various places across seam,
especially checking at the center. Make further
adjustments as needed.
5. Fully tighten screws.
Figure 6-5: leveling extension wings, method 2

6.5 Handwheel, knobs, levers

See Figure 6-3.
1. Remove tape from around shaft to expose
threads and shaft key (H
2. Ensure that set screw in handwheel (H
backed out sufficiently to prevent interference.
3. Ensure that key is in slot. Slide handwheel
onto shaft, aligning keyway with key.
4. Push handwheel on shaft as far as it will go,
then tighten set screw (H
5. Install locking knob (J, Figure 6-3) and handles
(G). Use wrench on flat of handles to tighten
against handwheels.

6.6 Rails and Fence

With extension wings properly mounted, the rails
®
and Accu-Fence assembly can now be mounted
to saw. Consult manual no. M-2195079B which
accompanies the fence, then proceed with sect. 6.7 below.

6.6.1 Switch bracket

See Figure 6-6.
The switch bracket is installed at the same time as
guide tube. Use two screws with washers which
are provided with the rails.
, Figure 6-3).
1
) is
2
).
2
Figure 6-6: installing switch

6.6.2 Wood Extension Table

For instructions on mounting the accessory wood
extension table, consult Accu-Fence manual, no.
M-2195079B.

6.7 Motor cover

See Figure 6-7.
Slide pins of motor cover into hinge barrels on saw.
Close motor cover until it catches on post on saw.
Note: The catch
adjustment to ensure proper closure. Loosen screw
and position as needed. Retighten screw.
Figure 6-7: installing motor cover

6.8 Table insert

See Figure 6-8.
Place insert into table opening. Verify that insert
lies flush with table surface by resting a straight
edge across it at various points. If insert is not flush
along its length, turn any of 6 set screws to raise or
lower that area of insert.
11
mechanism may require