Installing The Light Kit - HAMPTON BAY Irondale 1969 Manual Del Propietário

Installing the Light Kit

CAUTION To Reduce The Risk Of
Electric Shock, Disconnect The Electrical
S u p p l y C i r c u i t To T h e F a n B e f o r e
Installing Light Kit.
REMEMBER The fan blades must
already be attached to the fan.
Your fan and light kit though pre-wired
have been disassembled at the factory to
ease in shipping. Please follow these steps
to complete the installation of your fan and
light. TO REDUCE THE RISK OF FIRE
D O N O T E X C E E D M A X I M U M
WATTAGE RATING.
ATTENTION: The Energy Policy Act of
2005 requires this fan to be equipped with a
190 watt limiting device. If lamping exceeds
190 watts, the ceiling fan's light kit will shut
off automatically.
1.
Remove one of 3 screws and loosen other
two screws on the mounting ring. (Figure.
19)
2.Place the key holes on the switch cover
over the 2 screws previously loosened from
the mounting ring, turn mounting plate until
8
it locks in place at the narrow section of the
key holes. Secure by tightening 2 screws
previously loosened and the one previously
removed. (Figure 19)
3.While holding the light kit assembly
u n d e r y o u r f a n , s n a p t o g e t h e r t h e
connection plugs.(Figure 19)
4 . Remove three screw from the light kit for
future use. Install the light kit assembly
onto the switch cover with 3 screws
previously removed step 2. Be sure to
tighten all screws. (Figure 20)
5. Restore power and your ceiling fan is
ready for operations.
NOTE
LIGHT BULB HAVE NO WARRANTY, CAN BE
P U R C H A S E D AT L O C A L L I G H T B U L B
SPECIALTY STORE OR FROM OUR SERVICE
CENTER.
Mounting ring
Connector
Switch cover
Light Kit
Figure 19
Switch cover
Light Kit
Figure 20
Screws
Screws