Charging Process - auto XS CPL-2054U Manual Del Usuario

Ocultar thumbs

Tabla de contenido

Idiomas disponibles

− Disconnect the charger (see section "Disconnecting the charger").

• If the charger measures a battery voltage between 3.8 V and 7.3 V, the char-

ger will detect a 6 V battery.

− Start the 6 V charging program by pushing the mode button

• If the measured battery voltage is between 10.5 V and 15 V, the charger will

detect a 12 V battery.

− Push the mode button and select from the motorcycle

cold

charging programs.

Reactivation of deep-discharged 12 V batteries with pulse

charging

If the charger measures a battery voltage between 7.3 V and 10.5 V, this may

concern a full 6 V battery or a deep discharged 12 V battery.

− Push the mode button to start a charging program.

The charger will initiate an additional check measurement. The display will

alternate between two readouts during the measurement (see fig. H). The

measurement will take 1.5 minutes.

If after 1.5 minutes, the battery voltage measured is between 7.5 V and

10.5 V, the charger will recognize the battery as a 12 V battery and start the

motorcycle charging program

battery. The voltage indicator will blink.

Once the battery has reached a voltage of 10.5 V, the charger will switch to

normal continuous trickle charge. The charging current now corresponds

to the selected 12 V charging program. The voltage indicator will be shown

continuously.

Reactivation via pulse charging is the same for all 12 V charging pro-

grams.

For this reason, they can, even if the battery voltage is still below

10.5 V, still switch to the car

pending on the connected battery or the ambient temperatures.

Tap the mode button

If the battery voltage is still at 7.4 V or 7.5 V after 1.5 minutes, the battery is de-

fective. The charger will switch to standby mode

− Disconnect the charger (see section "Disconnecting the charger").