Makita HR3011FC Manual De Instrucciones página 10

1
► 1. Dust cap
NOTE: If the cap comes off from the dust cup, attach
it with its printed side facing up so that groove on the cap fits in the inside periphery of the attachment.
Tool hanger
Optional accessory
WARNING:
Do not use damaged tool hanger
and screw.
WARNING:
Use the screw provided with the
tool hanger only.
WARNING:
Before using the tool hanger,
check for damages, cracks or deformations, and
make sure that the screw is tightened.
CAUTION:
Install or remove the tool hanger
on a stable table or surface.
The tool hanger is intended for connecting the lanyard
(tether strap). To install the tool hanger to the tool,
follow the steps below.
1.
Disconnect the plug from the power source.
2. Insert the projections of the tool hanger into the
holes on the tool.
3. Tighten the screws firmly.
► 1. Tool hanger 2. Hole 3. Projection 4. Screw
DUST COLLECTION SYSTEM
For HR3011FC, HR3012FC only
Optional accessory
The dust collection system is designed to collect dusts
effectively when the concrete drilling operation.
1
► 1. Dust collection system
CAUTION:
Make sure that the tool is switched
off and unplugged before carrying out any work
on the tool. Failure to do so may result in personal
injury from accidental start-up.
CAUTION:
Always attach the filter to the
dust collection system. Failure to do so cause dust
inhalation.
CAUTION:
Check that the filter is not dam-
aged. Failure to do so may cause dust inhalation.
NOTICE:
Do not use the dust collection system
for core drilling or chiseling. The dust collection
system is intended for drilling only.
NOTICE:
Do not use the dust collection system
for metal or wood. The dust collection system is
intended for concrete only.
NOTICE:
Do not use the dust collection system
for drilling in wet concrete or use this system
in wet environment. Failure to do so may cause
malfunction.
10 ENGLISH
2
3
1
4