Stern QUADRAT Serie Manual De Instalación Y Mantenimiento página 4

PACK CONTENTS
1 x Qudrat base
1 x Wall rosette
1 x Corrugated
Tube
M 4 x 4 set screw
1 x Dual power
input box with
inlet nipple
and filter
B V E R S I O N S B V E R S I O N S
4
QUADRAT DPB / DPE
1 x Spout and attachments
(incl. electronic unit)
O P E R AT I O N O P E R AT I O N
This faucet features an IP67 dual power input box.
The product can be operated with a 9V battery or
a 9V transformer. In addition, when used with a
transformer the product contains an integrated
battery backup, for normal use during power supply
failures.
1 x Transformer
1 x Dual power
input box with
inlet nipple
and filter
E V E R S I O N S E V E R S I O N S
PRE-INSTALLATION INFO
CHECK CONTENTS
Separate all parts from the packaging and check each part with the pack contents sec-
tion. Pay attention to the variations of the different models.
Make sure all parts are accounted for before discarding any packaging material.
If any parts are missing, do not attempt to install your electronic faucet until you obtain
the missing parts.
Min 300 mm.
Bottom of the washbasin
PREPARATION FOR INSTALLATION
Flush the water supply lines thoroughly before installing the faucet. Do not allow dirt,
teflon tape or metal particles to enter the faucet. Shut off water supply.
IMPORTANT
All plumbing is to be installed in accordance with applicable codes and regulations.
Installations in Australia and New Zealand must comply with the requirements of
AS/NZS 3500.
WARNING
1) To avoid reflection problems keep a
distance of more than 300 mm. between
the sink and the spout.
2) This faucet model, with an infrared
sensor pointing down, is not intended to
be used together with a sink of a reflec-
tive material such as stainless steel.
3) If a sink strainer is straight below the
faucet sensor, use a strainer with a non
reflective finish (do not use a chrome
plated one).
5