Stern QUADRAT Serie Manual De Instalación Y Mantenimiento página 10

FAUCET INSTALLATION
8 Cut the temporary base cover.
Once the works on electricity,
plumbing and tiles have been
9
finished, assemble the wall rosette
through the product base.
Pull the four way connector out of
the product base, and lead it along
10
with the flexible tube, through the
corrugated tube.
Connect the flexible tube to the dual
11
power input box outlet.
Fix the product spout by inserting
12 the nipple into the product base and
tighten the screw.
16
QUADRAT DPB / DPE
FLEXIBLE
TUBE
FAUCET INSTALLATION
STEP 2 - CONNECTING THE WATER SUPPLY
IMPORTANT: This product was supplied with a self adjusting sensor. The ideal sensor
range for the specific location will be set automatically.
OBJECT
Before proceeding, check that no objects are
in front of the sensor besides the washbasin.
If your model is Quadrat DP B a 9V battery is already installed in the dual
power input box.
1
If your model is Quadrat DP E,
connect the transformer to the
transformer socket in the dual
power input box and plug it into
the electricity socket.
Connect the four contacts
connector to the dual power input
box.
2
Important: Make sure that the 4
contacts connector is connected
all the way through.
After you have connected the four
contacts connector to the dual
power input box, wait 15 seconds
3
in order to allow the system to set
the ideal sensor range.
As an indication that the self adjusting has taken place a LED in the sensor eye
will flash continuously. The solenoid valve will open and close for 1 second as an
indication that the ideal sensor range is set and the product is ready for use.
Turn on the central water supply
and Check for leaks.
If the automatically adjusted
4
sensor range is not satisfactory,
please refer to the section
entitled "Settings adjustment".
QUADRAT DPB / DPE
Now, remove the protective sticker that
covers the sensor.
O-RING VISIBLE – NOT CONNECTED PROPERLY
ONLY THE GROOVES ARE VISIBLE – CONNECTED PROPERLY
15 ABOUT
SECONDS
17