Troubleshooting - URBANGLIDE URBANRIDE 55 Manual Del Usuario

Problem
Power Switch is in OFF
The scooter won't
Battery is not charged.
start.
Wires or connectors areloase or
Battery requires charging.
Scooter run time
is short.
The battery will not accept full
The scooter runs
The scooter is overloaded.
very slowly.
The riding surface is not
Brakes are not adjusted correctly.

TROUBLESHOOTING

Possible Cause
position.
Charge thebattery fully. Charge the batte7c for 7 hours for
the very first time and 4 hours for subsequent charging.
Dismantle the scooter and check the power connection
and controller connection for any loosening. Reconnect
unplugged.
Fully charge the battery. Charge the battery 7 hours for
Make sure the wall outlet switch is on. Battery may need
charge.
battery lite is 1 to 2 years depending on scooter conditions
Make sure the scooter is not overloaded. This product is
designed to sustain a maximum of 50kg. An excessive
the scooter refuse to start. Do not ride uphill or use the
On ride on solid, even, clean, and dry surfaces such
suitable.
Solution
Switch the Power Switch to ON.
them when necessary.
the very first time and 4 hours for a subsequent
charging.
See that the charger plug is connected to a 230V
power supply.
to be replaced. Even with proper care, rechargeable
batteries do not las! forever. The average rechargeable
and use.
overload triggers off automatic protection and makes
scooter to tow any cargo. Do not overload the scooter,
which may cause the battery and the electronics to age
prematurely and damage the power system.
as sidewalks and flat ground.
Refer to the instruction manual on adjusting brakes.
9