CAUTION: Do not install the detachable panel before connecting the unit.
1.The unit is designed for negative terminal of the battery which is connected to the vehicle
metal. Please make sure this is connected before starting installation.
2. If the car interior is extremely hot, as after being parked in the sun, do not use the player until
the car has been driven for a while to cool off the interior.
3. Press the RELEASE button to flip down the front panel (see fig.1), then take away the front
panel (see fig.2) and put it in the protective case (see fig.3) for safe keeping.
4. Install the front panel back into its bracket and then push it back into position for playing (see fig.4).
NOTE:
You must use 4 ohms impedance of speaker in your speaker system to reduce the distortion
during high volume level.
INSTALLATION
1. Choose the mounting location that will not interfere the normal driving function of the driver.
2. Avoid installing the unit in a place where it would be subjected to dirt, dust, damp, high
temperature and excessive vibration.
3. Please install appendixes provided by the manufacturer.
GB 5
USER MANUAL
M1.TAPPING SCREW
M2. PLAIN WASHER
M3. SPRING WASHER
M4. HEX NUT
M5. HEX BOLT
M6. SLIDE BRACKET HOUSING
M7. CONSOLE
M8. DASH BOARD
M9. METAL MOUNTING STRAP
M10. KEY PLATE
M 11. PLASTIC TRIM OUT
USER MANUAL
NOTE:
If you want to take CHASSIS out of the SLIDE BRACKET HOUSING, remove the PLASTIC
OUTLINE first, then insert the two KEY PLATES into left and right side of chassis as above
illustration.
PRECAUTIONS AND MAINTENANCE
1.This unit is designed for negative ground operation only.The equipment can be used safely, if
the negative terminal of the battery is connected to the vehicle metal work.
2.Do not use speakers of impedance less than 4 ohms; and allow the speaker wires to be
shorted together when the unit is switched on.
Otherwise it may overload or burn out the power amplifier stage.
3.If the car interior is extremely hot, as after being parked in the sun, do not use the player until
the car has been driven for a while to cool off the interior.
4.Take care of your tape cassette to preserve the quality of the recordings. Do not expose them
to direct sunlight. Store them in a place protected from dirt and dust and avoid handing with
greasy or oily hands.Also, keep the away from magnets, and motors of the permanent magnet type.
5.It is not advisable to use cassette tapes longer than C-60(30 minutes per side) in automobile
players, since the tape is too thin and tends to become easily entangled. Always remove cartridge
from your tape player as soon as play is finished.
6.The capstan and tape head should be cleaned about once every six months with a soft cloth or
cotton-wool swab, moistened with alcohol.
This will serve to maintain the richness and clarity of sound, and prevent loss of volume. Do not
use a screwdriver, or ferrous metal rod, in carrying out the above cleaning. See illustration.
7.A loosely wound cassette tape will get damaged. Prior to using such tape, tighten it in a manner
as guided by Fig2. A carelessly wound cassette tape will cause unnecessary pressure on the tape
resulting in the cassette springing out while the tape is running. For prevention, rewind the tape
through fast forwarding or rewinding.
GB 6