Philips QC5005/10 Manual De Instrucciones página 2

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 4
ENGLISH
General description (Fig. 1)
A Cutting element
B On/off switch
C Mains cord with adapter
D Hair clipping comb attachment
E Adjustment button
F Cleaning brush
G Hairdresser's comb
H Hair chamber
Important
Read this user manual carefully before you use the
appliance and save it for future reference.
Danger
-
Make sure the adapter does not get wet.
Warning
-
Check if the voltage indicated on the adapter and on
the appliance corresponds to the local mains voltage
before you connect the appliance.
-
The adapter contains a transformer. Do not cut
off the adapter to replace it with another plug, as
this causes a hazardous situation.
-
This appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a
person responsible for their safety.
-
Children should be supervised to ensure that they
do not play with the appliance.
Caution
-
Do not use the appliance in the bath or in the
shower.
-
Use and store the appliance at a temperature
between 15°C and 35°C.
-
If the adapter is damaged, always have it replaced
with one of the original type in order to avoid a
hazard.
-
Do not use the appliance when the clipping
attachment or one of the combs is damaged or
broken as this may cause injury.
-
This appliance is only intended for clipping human
scalp hair. Do not use it for any other purpose.
-
If the appliance is subjected to a major change in
temperature, pressure or humidity, let the appliance
acclimatise for 30 minutes before you use it.
Compliance with standards
This Philips appliance complies with all standards
regarding electromagnetic fields (EMF). If handled
properly and according to the instructions in this user
manual, the appliance is safe to use based on scientific
evidence available today.
Using the appliance
Clipping with the hair clipping comb
attachment
Note: Make sure your hair is clean and dry. Do not use the
appliance on freshly washed hair.
1
Comb your hair with a styling comb in the
direction of hair growth. (Fig. 2)
2
Slide the comb attachment into the guiding grooves
of the appliance ('click'). (Fig. 3)
Make sure that the comb attachment has been properly
slid into the grooves on both sides.
3
To set the comb attachment to the desired hair
length, press the adjustment button (1) and slide
the comb attachment to the desired hair length
setting (2). (Fig. 4)
Hair length settings
With the hair clipping comb attachment attached, the
appliance has 7 different hair length settings:
Hair length setting
Resulting hair length
1
3mm
2
6mm
3
9mm
4203.000.4546.2
Hair length setting
Resulting hair length
4
12mm
5
15mm
6
18mm
7
21mm
4
Put the adapter in the wall socket.
5
Wait a few seconds and then slide the on/off switch
to the 'on' position.
6
Move the appliance through the hair slowly.
Tips:
-
Start to clip at the highest setting of the comb
attachment and reduce the hair length setting
gradually.
-
Write down the hair length settings you selected to
create a certain hairstyle as a reminder for future
clipping sessions.
-
To clip in the most effective way, move the appliance
against the direction of hair growth. (Fig. 5)
-
Try different directions (upward, downward or
across), because hair doesn't all grow in the same
direction.
-
Make overlapping passes over the head to ensure
that the appliance catches all the hairs that need to
be cut.
-
Make sure that the flat part of the hair clipping comb
attachment is fully in contact with the scalp to obtain
an even cutting result.
-
To achieve a good result with curly, sparse or long
hair, you can use a comb to guide the hair towards
the appliance.
-
Regularly remove cut hair from the comb
attachment. If a lot of hair has accumulated in
the comb attachment, remove it from the appliance
and blow and/or shake the hair out of it.
Contouring without hair clipping comb
attachment
You can use the appliance without comb attachment
to cut your hair very close to the skin (0.8mm) or to
contour the neckline and the area around the ears.
Note: When you use the appliance without comb
attachment, it cuts the hair very close to the skin.
1
To remove the comb attachment, press the
adjustment button (1) and pull the comb
attachment off the appliance (2). (Fig. 6)
2
Before you start to contour the hairline round the
ears, comb the hair ends over the ears.
3
Tilt the appliance in such a way that only one
edge of the cutting element touches the hair
ends. (Fig. 7)
4
Only cut the hair ends. The hairline has to be close
to the ear.
5
To contour the neckline and sideburns, turn the
appliance and make downward strokes. (Fig. 8)
6
Move the appliance slowly and smoothly. Follow the
natural hairline.
Cleaning
Do not use abrasives, scourers, compressed air or
liquids such as alcohol, petrol or acetone to clean the
appliance.
Only clean the appliance and the adapter with the brush
supplied.
Do not use any sharp objects to clean the appliance.
Clean the appliance after every use.
1
Make sure the appliance is switched off and
disconnected from the mains before you clean it.
2
To remove the comb attachment, press the
adjustment button (1) and pull the comb
attachment off the appliance (2). (Fig. 6)
3
Clean the cutting element and the hair chamber
behind the cutting element with the brush
supplied (Fig. 9).
Note: The cutting element cannot be detached and the
appliance cannot be opened.
The appliance does not need any lubrication.
Replacement
The mains cord and adapter of this appliance cannot be
replaced. If the mains cord or the adapter is damaged, the
appliance must be discarded.
Only the hair trimming comb attachment is replaceable.
Environment
-
Do not throw away the appliance with the normal
household waste at the end of its life, but hand it in
at an official collection point for recycling. By doing
this, you help to preserve the environment (Fig. 10).
Guarantee and service
If you need service or information or if you have a
problem, please visit the Philips website at
www.philips.com or contact the Philips Consumer Care
Centre in your country (you find its phone number in
the worldwide guarantee leaflet). If there is no Consumer
Care Centre in your country, go to your local Philips
dealer.
2/8
loading