Appliance Setup - Kenmore KFU015AWD Serie Manual De Uso Y Cuidado

Appliance Setup

This Use & Care Guide provides specific
operating instructions for your model. Use
the unit only as instructed in this Use & Care
Guide. Before starting the appliance, follow
these important setup steps.
Installation
• Choose a place that is near a grounded
electrical outlet. Do Not use an extension
cord or an adapter plug.
• For the most efficient operation, the
appliance should be located where
surrounding temperatures will not exceed
110°F (43°C). Temperatures of 32°F (0°C)
and below will NOT affect appliance
operation. Additional compressor heaters
are not recommended.
• Allow space around the unit for good air
circulation. Leave a 1-inch (25.4 mm)
space at the back and on top and a
3/8-inch (9.5 mm) space on the sides of
the appliance for adequate circulation.
Leveling
The appliance must have all bottom corners
resting firmly on a solid floor that is strong
enough to support a fully loaded appliance.
It is Very Important for the appliance to be
level in order to function properly. If not
level, the door may be misaligned and not
close or seal properly, causing cooling,
frost, or moisture problems.
The appliance is equipped with adjustable
front leveling feet. Turn the foot clockwise
to heighten (H) the side of the unit. Turn
counterclockwise to lower (L) the side. Adjust
each side as needed until front of unit is
level. Also adjust so that front of unit is 1/4˝
higher than back, so that door stays closed.
냉동고_K@FU015AWD(EN+ES).indd 5
Cleaning
• Wash any removable parts, the
appliance interior, and exterior with mild
detergent and warm water. Wipe dry.
Do not use harsh cleaners on these
surfaces.
• Do not use razor blades or other sharp
instruments, which can scratch the ap-
pliance surface when removing adhesive
labels. Any glue left from the tape can
be removed with a mixture of warm
water and mild detergent, or touch the
residue with the sticky side of tape
already removed. Do not remove the
serial plate.
Energy Saving Ideas
for Freezer Mode
• The freezer should be
located in the coolest area
of the room, away from
heat producing appliances
or heating ducts, and out of
direct sunlight.
• Let hot foods cool to room temperature
before placing in freezer. Overloading
the freezer forces the compressor to run
longer. Foods that freeze too slowly may
lose quality or spoil.
• Be sure to wrap foods properly, and
wipe containers dry before placing
them in the freezer. This cuts down on
frost build-up inside the freezer.
• Do not line freezer shelves and bins
with aluminum foil, wax paper, or paper
toweling. Liners interfere with cold air
circulation, reducing freezer efficiency.
• Organize and label food to reduce lid
openings and avoid extended searches.
• Remove as many items as needed at one
time, and close door as soon as possible.
5 5
2021-05-06 오전 10:37:38