2.3 Charging the battery batteries
a. Insert the small plug on the end of the mains adaptor into the power-in connection jack at the back of
the desktop charger.
b. Plug the mains adaptor into a 240V AC, 50Hz main socket with the switch on the socket set to Off.
c. Switch On the main socket.
The ZD-360 must be charged using the mains adaptor provided.
Using any other adaptor will result in non-compliance with
EN60950-1 and will invalidate any approvals & warranty.
d. Place the ZD-360 units in the charge cradle in an upright position. The charge LED indicators will light
up.
e. It takes about 10 hours to fully recharge the batteries if they are completely run down. New batteries
take up to 14 hours to fully charge.
Important:
Always turn off the PMR units when charging. This
will shorten the charging time.
Main socket
f. Charging the battery batteries (using adaptor)
Lift the charge socket cover located on the right side of the handset.
Insert the round connector of the 9.0V DC/200mA adaptor into
the charge jack.
Plug the mains adaptor into a 240V AC, 50Hz main socket with the switch on
the socket set to Off. Use only the power supplies listed in the user
instruction.
Then switch ON the main socket.
Battery meter
The battery meter is located in the left corner of the LCD screen. It appears like a battery with three bars
inside. These indicate the amount of power available. When the battery level reaches it minimum level in
PMR on mode, unit will emit two beep tones and automatically the unit will power off.
The ZD-360 can detect the battery charge in 4 levels;
Battery charge at high level.
Battery charge at medium level.
Battery charge at low level. At this level, the ZD-360 will emit a "beep" sound for every 10
seconds in normal mode.
Important: Charge the unit for 10-14 hours.
Battery charge at very low level. When the battery level reach it minimum level in ZD-360 on mode, unit
will emit two beep tone and automatically turn off the power and proceeds to watch mode.
Important: Charge the unit for 10-14 hours.
Charge jack
Mic/spk jack