BRASS AKRON OZZIEMASTER 922 Instrucciones De Instalación, Operación Y Mantenimiento página 6

Figure 4
DUAL.INLET/.FLANGE.
ADAPTER
OPERATING INSTRUCTIONS
A . . FLOWING.WATER
. Slowly.charge.the.hose.line.with.water . . Build.pressure.until.the.gauge.reads.the.rated.tip.pressure . . A.minimum.
operating.pressure.of.70.psi.is.required . .
. NOTE: The unit will discharge some water from the oscillation mechanism during use.
B . . CHANGING.SWEEP.RANGE
. 1 . . Before.adjusting.the.sweep.range,.stop.the.oscillation.by.depressing.the.oscillation.ON/OFF.knob . .
. 2 . . Move.the.travel.control.knobs.to.desired.position . . The.left.knob.controls.the.right.travel.and.the.right.knob..
. controls.the.left.travel . . (See.Figure.4)
. 3 . . Restart.oscillation.by.gently.pulling.oscillation.ON/OFF.knob.out .
C . . TO.STOP.UNIT.IN.PLACE.AND.USE.AS.A.NON-OSCILLATING.MONITOR
. Depress.the.oscillation.ON/OFF.knob.when.the.nozzle.reaches.desired.position .
D . . TO.CHANGE.THE.ELEVATION.POSITION
1 . . Before.adjusting.the.elevation,.STOP.the.oscillating.motion.by.pushing.in.on.the.oscillation.ON/OFF.knob .
2 . . Loosen.the.elevation.brake.knob.and.adjust.the.elevation.to.desired.position . . (See.Figure.4).Once.position.is.
reached,.tighten.the.elevation.brake.knob .
. 3 . . Restart.oscillation.by.gently.pulling.oscillation.ON/OFF.knob.out .
E . . AFTER.SHUTDOWN
1 . . Remove.hose .
2 . . Tilt.the.unit.and.drain.as.much.water.as.possible.from.the.body.of.the.unit .
3 . . Move.the.discharge.outlet.back.and.forth.by.hand.to.drain.as.much.additional.water.as.possible.from.the.unit . .
This.minimizes.the.possibility.of.corrosion.and.freezing .
4 . . If.the.unit.was.used.for.foam.application,.with.salt.water.or.with.blackish.or.dirty.water,.be.sure.to.operate.with.
clean.water.for.at.least.5.minutes.after.shut.down .
OSCILLATING.ON/OFF.KNOB
ELEVATION.BRAKE.KNOB
4
CONTROL.KNOBS
.