3M MT Serie Manual Del Usuario página 4

GB
WS Headset XP
The product(s) described in this user instruction is in conformity with the provisions set out in the Personal protective
euqipment (PPE) directive 89/686/EEC and the Radio equipment and Telecommunications terminal equipment directive
(R&TTE) 1999/5/EC. Thereby it fulfils the requirements for CE marking.
Model designation:
MT*H7AWS5
MT*H7P3*WS5
MT*H7BWS5
1. WHAT IS WHAT
(B:1) Headband wire (stainless steel)
(B:2) Two-point fastener (headband wire)
(B:3) Ear cushion (PVC foil and Polyester foam)
(B:4) Headband padding (PVC)
(B:5) On/Off/Mode
(B:6) VOL+, VOL –
(B:7) Speech microphone
(B:8) Bluetooth button
Note:
B:1 Neckband version: stainless steel. Helmet attachment version: stainless steel.
B:4 Neckband cover: POE
2. FITTING AND ADJUSTMENT
Over-the-head band (Fig. C)
Slide the cups out and place the headset over your ears so that the ear cushions fit snugly. (1) Adjust the height of the cups by sliding them up or down whilst holding the headband in place. (2)
The headband should be positioned across the top of the head. (3)
Helmet attachment (Fig. D)
Snap the helmet attachment into the slot on the helmet (1).
The cups can be set in two positions: Ventilation position (2) or working position (3).
When in use, the cups must be placed in working position!
Press the headband wires inwards until you hear a click on both sides and ensure that the shell or the headband wires do
not press against the lining or edge of the helmet, which could cause noise leakage.
Notice! Never place cups with humid foam on the helmet! (4)
Helmet mounted version approved combinations (Fig. K)
The helmet mounted version of these ear-muffs should be fitted to, and used only with, the industrial safety helmets listed in (Fig K).
1. Helmet brand
2. Helmet model
3. Helmet attachment
4. Headform size
S=small, N=medium, L=large)
3. USAGE/FUNCTIONS
3:1 Switching the headset on and off
Press and hold the On/Off/Mode button (B:5) for two seconds to switch the headset on or off.
3:2 Bluetooth pairing
The headset can be paired with and connected to Bluetooth units that support the profiles A2DP, HFP or HSP.
2
Headband version
Helmet attachment version
Neckband version