Eu Declaration Of Conformity - Atlas Copco MT Focus 6000 Manual Del Usuario

MT Focus 6000
Technical data
Product data
Tool data
Voltage (V)
Power
Storage temperature
Operating temperature
Declarations
Notice
Many events in the operating environment may af-
fect the tightening process and shall require a vali-
dation of results. In compliance with applicable
standards and/or regulations, we hereby require
you to check the installed torque and rotational di-
rection after any event that can influence the tight-
ening result. Examples of such events include but
are not limited to:
• initial installation of the tooling system
• change of part batch, bolt, screw batch, tool,
software, configuration or environment
• change of air- or electrical connections
• change in line ergonomics, process, quality
procedures or practices
• changing of operator
• any other change that influences the result of
the tightening process
The check should:
• Ensure that the joint conditions have not
changed due to events of influence.
• Be done after initial installation, maintenance
or repair of the equipment.
• Occur at least once per shift or at another suit-
able frequency.

EU DECLARATION OF CONFORMITY

We, Atlas Copco Industrial Technique AB,
S-105 23 STOCKHOLM SWEDEN, declare under
our sole responsibility that the product (with name,
type and serial number, see front page) is in con-
formity with the following Directive(s):
2011/65/EU, 2014/30/EU, 2014/35/EU
36 V d.c.
240 W
+60 °C
(+140 °F)
+40 °C
(+104 °F)
© Atlas Copco Industrial Technique AB - 9834 3579 00
Harmonised standards applied:
EN 61000-3-2:2006+A1+A2, EN
61000-3-3:2013, EN 61000-6-2:2005, EN
61000-6-3:2007+A1, EN 61010-1, EN
61010-2-201, EN 61326-1:2013
Relevant technical information can be requested by
authorities only.
Quality Manager, Atlas Copco Industrial Tech-
nique AB, S-105 23 Stockholm Sweden
Stockholm, 30 June 2017
James McAllister, Managing Director
Signature of issuer
WEEE
Information concerning Waste of Electrical and
Electronic Equipment (WEEE):
This product and its information, meets the re-
quirements of the WEEE Directive (2012/19/EU),
and must be handled in compliance with the direc-
tive.
The product is marked with this symbol:
Products with the symbol of a crossed out wheelie
bin with a single black line underneath, indicates
that parts within the product must be handled in
compliance with the WEEE Directive. The entire
product, or the WEEE parts, can be sent to your
"Customer Centre" for handling.
Batteries are marked with the symbol of a crossed
out wheelie bin without a single black line under-
neath. The battery must be recycled either accord-
ing to local regulations or sent to your "Customer
Centre" for handling.
Safety Information
3