Rh Min/Max; Co Settings; Co Setpoint; Co Hysteresis - TechGrow T-2 Pro Manual De Instrucciones

Humidity day 60%
Hum. night 60%
=> Humidity +/- 3%
>> NEXT >>

10.3 RH min/max

Select >> NEXT >> and press the PTK.
Humidity day 60%
Hum. night 60%
Humidity +/- 3%
=> >> NEXT >>
You enter the next screen that displays the measured
minimum and maximum RH level.
Select "Reset min/max" to reset and press the PTK.
RH Min 49%
RH Max 54%
=> Reset min/max
>> NEXT >>
Select >> NEXT >> and press the PTK to return to the
main screen.
RH Min 49%
RH Max 54%
Reset min/max
=> >> NEXT >>
11. CO settings
2
You are in the main screen. Press the PTK and select
"CO2".
TMP = 29.8 °C
RH = 63 %
=> CO2 = 848 PPM
CO2 cntr 00:00:00
You enter the next screen where you can adjust the
desired CO level, the hysteresis and the alarm value:
2
____________________________________________________________________________________________________________________________
TechGrow | Innovative Growing Solutions
CO2 level 700
CO2 +/- 50
CO2 ALARM 1400
>> NEXT >>
>> NEXT >>
11.1 CO setpoint
2
Select "CO2 level" (setpoint) and press the PTK.
Select the desired CO concentration.
2
Press the PTK to confirm or wait a few seconds for
automatic confirmation.
=> CO2 level 700
CO2 +/- 50
CO2 ALARM 1400
>> NEXT >>
>> NEXT >>
11.2 CO hysteresis
2
CO2 level 700
=> CO2 +/- 50
CO2 ALARM 1400
>> NEXT >>
>> NEXT >>
Select "CO2 +/-" (hysteresis) and press the PTK.
Select the desired value.
Press the PTK to confirm or wait a few seconds for
automatic confirmation.
11.3 CO alarm value
2
Here you can set the CO
2
is exceeded, the fan will speed up to the "BOX max"
position in "Automatic" mode.
In "Manual" mode the fan will always run at "BOX
power" speed.
ATTENTION: Always set the CO
level above CO set + hys, otherwise CO
2
constantly be dosed and sucked.
CO2 level 700
CO2 +/- 50
=> CO2 ALARM 1400
>> NEXT >>
>> NEXT >>
Select "CO2 ALARM" and press the PTK.
Set the desired value.
alarm value. If the alarm level
alarm value to a
2
will
2
30