Gas Connection; Electrical Connection - Furrion FGHWCLDA-BL Manual De Instrucciones

3. Push a little and lift to remove the top glass cover from the
cooktop. (Fig. 2)
Fig. 2
4. Slide the cooktop into the cabinet opening. Verify that the
cooktop is level from side to side and front to rear. (Fig. 3)
Fig. 3
5. Fix the cooktop in the cabinet opening on both left and
right using four self-tapping screws on both left and right
(2 screws each side). (Fig. 4)
Fig. 4

Gas Connection

WARNING
Gas supply pipe must be installed with clearance from
knives contacting or cutting gas lines.
Connect a propane supply line with a ⅜ " Flare Female
connection to the cooktop in the upper left rear corner of the
cabinet. (Fig. 5) Tighten the gas line joint to the cooktop using
8
2 wrenches.
IMPORTANT: Leave adequate space around the gas supply
pipe in case of bend or damage during installation. Make sure
the gas supply pipe cannot contact any moving parts after
installed. Be sure all openings in the cabinet around the gas
line are sealed at time of installation.
Fig. 5

Electrical Connection

CAUTION
PRODUCT DAMAGE HAZARD
● Connect to 12V DC service only.
● DO NOT connect to a circuit fused for more than 3
amps.
● DO NOT hi-pot range unless electronic ignition system
has been disconnected.
Connect a positive 12V power supply wire to the cooktop
black 12V light wire and a negative 12V power supply wire to
the cooktop white 12V light wire. (Fig. 6)
NOTE: Ensure to connect the wires with the correct polarity.
Black is "+" and White is "-".
Fig. 6
+
12V DC
Switch
-
Wiring Diagram
Ignition
Right Center
Left
Knob
Burner Burner
Burner
LED
Knob LED Knob LED
Knob LED