Anti-Tip Bracket Installation; Electric Connection - Furrion FT24N62R-SS Manual Del Usuario

Anti-Tip Bracket Installation

WARNING
To reduce the risk of tipping of the appliance, the appliance
must be secured by properly installing anti-tip devices.
To check if the devices are installed properly, remove the
storage drawer and verify that the anti-tip devices are
engaged into the bracket.
The anti-tip bracket must be properly installed to reduce the
risk of tipping due to abnormal use or improper oven door
loading. Always follow instructions below to install the anti-tip
bracket.
1. Position the anti-tip bracket against the wall on the floor
in the cutout area, make sure the U-notch is facing inward
and the U-notch center is 10¼" (260.5mm) distance to the
cutout centerline. (Fig. 3)
NOTE:
− The anti-tip bracket can be installed either on the left or
right side of the cutout.
− If the range is not pushed against the wall then the
bracket may need to be adjusted forward to ensure the
foot is locked into the bracket.
Fig. 3
2. Determine and mark the drilling position through the two
mounting holes in the bracket.
3. Fix the two mounting bolts into the floor. (Fig. 4)
NOTE: If install on concrete floors. Take the length of
the provided mounting bolts as a reference and drill two
holes on the floor using a masonry drill in proper depth.
Insert the mounting anchor (not provided) into the 2 drilled
holes, insert the 2 bolts through the anti tip bracket and
into the anchors.
Fig. 4
9
Mounting anchors (not provided)
for masonry/cement floors.

Electric Connection

WARNING
ELECTRIC SHOCK HAZARD
● Disconnect electrical power before servicing.
● Replace all parts and panels before operating.
● Failure to do so can result in death or electrical
shock.
BEFORE MAKING THE ELECTRICAL CONNECTION,
MAKE SURE THAT:
● Do not use an extension cord.
● Check with a qualified electrician or service technician if
you are in doubt as to whether the appliance is properly
grounded. Don't modify the power supply cord plug. If it
will not fit the outlet, have a proper outlet installed by a
qualified electrician.
● This range must be supplied with the proper voltage and
frequency as specified on the rating label which is located on
the oven door of the appliance (Fig. 5). And connected to an
individual properly grounded branch circuit, protected by a
circuit breaker or fuse having amperage as specified on the
rating label. The rating label is located on the oven door of
the appliance.
Rating Label
Fig. 5
● The safety circuit-breaker and the electrical system are
able to withstand the load of the appliance. Refer to the
rating label of the range in case you need to verify any of the
electrical requirements.
● The manufacturer is not liable for any direct or indirect
damage caused by faulty installation or connection. It is
therefore necessary that all installation and connection
operations are carried out by qualified personnel complying
with local codes and regulations.
● Ensure the 50-amp circuit is installed before connecting
electric to the range.
● Electric connection for U.S.A market, because range
terminals are not accessible after range is in position,
flexible service conduit or cord must be used, please see
the section of Electrical Connection USA Installations
(FT24N62R-SS).
● Electric Connection for Canadian market, please see
the section of Electrical Connection for Canada
Installations (FT24N62C-SS).