Getting Started; How To Use - Remington CERAMIC HC363C Manual Del Usuario

ENGLISH

GETTING STARTED

CHARGING YOUR HAIRCLIPPER
Before using your hair clipper for the fi rst time, charge for 14-16 hours.
Ensure the product is switched off.
Connect the charging adaptor to the product and then to the mains.
The charging indicator will light up.
Your clipper cannot be overcharged. However, if the product is not going to be used for an
extended period time (2-3 months), unplug it from the mains and store.
Fully recharge your hairclipper when you would like to use it again.
To preserve the life of your batteries, let them run out every six months then recharge for
14-16 hours.
CORDED USE
Connect the charging adaptor to the product and then to the mains.
CAUTION: Extended mains only use will result in the reduction of the battery life.

HOW TO USE

Before starting the cut
Inspect the clipper making sure that it is free from hair and dirt.
Seat the person so that their head is approximately at your eye level.
Before cutting, always comb the hair so it is tangle free and dry.
To attach a comb
Hold the comb with its teeth upward
Slide it onto and along the clipper blade until the front of the comb fi rmly sits against the
clipper blade.
To remove the comb
Holding the clipper with the blades facing away from you, fi rmly push the comb upward
and away from the blades.
2
061015_REM_HC363_RZ_02.indd 2-3 061015_REM_HC363_RZ_02.indd 2-3
Each comb attachment is marked accordingly on its outside middle surface. (3mm, 7mm,
9mm, 12mm, 18mm, 25mm, left and right ear guide)
Replacement combs available. Model: SP254
INSTRUCTIONS FOR HAIR CUTTING
Note: For even cutting, allow the comb attachment/blade to cut its way through the hair.
Do not force it through quickly. If you are cutting for the fi rst time, start with the maxi-
mum comb attachment.
STEP 1 – Nape of the neck – PICTURE 1
Use 3mm or 7mm guide comb.
Hold the clipper with the blade teeth pointing upwards. Begin starting at the centre of the
head at the base of the neck.
Slowly lift the clipper, working upwards and outwards through the hair, trimming just a
little at a time.
STEP 2 – Back of the head – PICTURE 2
With the 12mm or 18mm guide comb attached, cut the hair at the back of the head.
STEP 3 – Side of the head – PICTURE 3
With the 3mm or 6mm guide comb attached, trim sideburns. Then change to the longer
9mm guide comb and continue to cut to the top of the head.
STEP 4 – Top of the head – PICTURE 4
With the 18mm or 25mm guide comb attached, cut hair on top of the head against the
direction in which the hair normally grows.
For longer hair on top, use without a guide comb. Lift the hair on top of the head with a
small hand comb. Cut over the hand comb with the hair lifted or hold the hair between the
fi ngers to lift it and cut it to the desired length.
Always work from the back of the head.
3
15.11.2006 15:12:44 Uhr 15.11.2006 15:12:44 Uhr