Charging The Battery - Conceptronic CBTGPS Guía De Instalación Rápida

ENGLISH

4.2 Charging the battery

Before you use the CBTGPS for the first time, please charge the battery until it is
fully charged.
Connect the retractable USB cable to the Power Adapter, the Car cigarette lighter
adapter or a free USB port on your computer and connect the other end to the
power jack of the CBTGPS (mini USB type).
This will begin to charge the battery.
When the battery is fully charged Battery Status LED turns off.
Note: When you charge the GPS Receiver through the USB port of your computer,
make sure the device is powered off.
If the device is powered on, the computer will show a message "Not
recognized hardware". Ignore this message.
4.3 Turn on the GPS Adapter
When the battery of the GPS Receiver is charged the device is ready to use. Turn on
the GPS Receiver with the power switch at the side of the device.
The Bluetooth® Status LED will turn on.
Note: When the CBTGPS is used for the first time, it will take up to 3 minutes to
get the satellite constellation and fix your position; this is called "Cold
Start". If you replace the battery, the CBTGPS will do a "Cold Start"
again. When the battery is completely empty, the CBTGPS will also
perform a "Cold Start" after charging.
4.4 Pairing the GPS receiver with your Smartphone or PDA
You can pair your Smartphone or PDA with the GPS Receiver when the GPS Receiver
is turned on and not currently connected to another to another Smartphone or PDA.
Note: For pairing instructions we refer to the manual of your Smartphone or
PDA.
16