Stanley FMHT77496 Manual De Instrucciones página 12

Batteries and Power
Battery Installation / Removal
(See figure and to reference battery location of
F G
laser tool and remote control)
Laser Tool
(See figure
• Press tabs to open battery compartment and slide out.
• Install / Remove batteries. Orient batteries correctly
when placing into laser tool.
• Securely close and lock battery compartment cover.
IR Remote Controller
• Open battery compartment by sliding cover off.
• Install / Remove batteries. Orient batteries correctly
when placing into laser tool.
• Securely close and lock battery compartment cover.
WARNING:
• Pay close attention to the battery holder's (+)
and (-) markings for proper battery insertion.
Batteries must be of same type and capacity. Do
not use a combination of batteries with different
capacities remaining.
Charging Battery
• For best life, the rechargeable battery must be charged for
4 hours before first use.
• Plug charging / power adapter plug into charging jack of
laser tool
• Plug charging / power adapter into power outlet (110 V or
220 V) with appropriate plug receptacle.
• The LED on the charging / power adapter will light RED
during charge.
• Leave battery to charge for approximately 4 hours to reach
full charge.
• When battery is fully charged unplug the charging / power
adapter from laser tool and power outlet.
• The LED on the charging / power adapter will light GREEN
when charge is complete.
12
)
F
(See figure )
G
FMHT77496 / FMHT77429 / FMHT77439 / FMHT77497 / FMHT77427
WARNING:
• Use charging / power adapter only with Ni-MH
battery pack supplied. Charging any other
type of battery may result in damage and/or
personal harm.
WARNING:
• The battery and charging / power adapter can be
damaged if damp. Always store and charge the
tool in a dry and covered place.
NOTE:
• For best battery life, it is recommended to charge the
battery once it has been fully discharged and avoid letting
charge for > 10 hours at a time.
Operating with Charging / Power
Adapter
• Laser tool can operate while plugged into charging / power
adapter.
• Functions and controls of laser tool are the same as when
not plugged into charging / power adapter.
Set Up
Positioning
(See Feature Set to reference which models offer Auto-
Levelling in the given positions)
Horizontal Position (See figure
• Place laser tool down on its bottom. Be sure surface is
near level. Press
Vertical Position (See figure
• Place laser tool down on its side, handle facing up. Be
sure surface is near level. Press
)
A
to power ON.
)
B
to power ON.