Rear Panel - TEAC PROFESSIONAL TASCAM X-15 Manual Del Usuario

Features and controls

Rear Panel

d
AC Adaptor in
Use this jack to connect the PS-P17X AC adapter
supplied with your X-15.
Insert the plug following the arrow position of the AC
adapter plug, and the white dot on the rear panel of the
unit.
WARNING
DO NOT use any adapter with the X-15 except the
PS-P17X adapter supplied with the X-15.
Connect the AC adapter jack to the X-15 in the way
shown on the illustration on the rear panel of the
X-15. If you connect the AC adapter in any other
way, you may damage the X-15.
f
POWER switch
Make sure the power is off when you connect or
disconnect the AC adapter.
g
BOOTH OUTPUT
These unbalanced RCA jacks output the pre-MASTER
fader signal, the level of which is then adjusted using the
BOOTH OUT control.
h
REC OUTPUT
These unbalanced RCA jacks output the pre-MASTER
fader signal. This can be useful for a number of purposes:
for example, you could connect a recorder to these jacks,
and record your live performance without the MASTER
level affecting the recording.
j
MASTER OUTPUTS (UNBAL)
These unbalanced RCA jacks output the master output
signals, whose levels are set with the MASTER fader.
k
MASTER OUTPUTS (BAL)
These balanced XLR connectors output the master output
signals, whose levels are set with the MASTER fader.
Connections are follows:
GND: Pin 1
HOT: Pin 2
COLD: Pin 3
l
FADER START connectors
Connect devices supporting the fader start operation to
these mini-jacks.
You can enable the cross-fader start function
independently for the A and B outputs.
Move the cross-fader to start and/or stop (back cue) the
PGM A or B source automatically.
NOTE
The fader start signal is output from the tip, and the
fader stop (back cue) signal is output from the
sleeve. The ground for these connections is
provided by the signal ground of the device to
which the fader start is made.
;
LINE inputs (1-6)
Connect line level equipment, such as CD players,
cassette decks, DAT decks, MD decks, etc. to these
unbalanced RCA connectors
z
PHONO inputs (1 and 2)
Connect turntables equipped with MM (moving magnet)
cartridges to these unbalanced RCA connectors.
WARNING
Never connect any other type of equipment to these
connectors and do not connect turntables to any
other connectors.
English
7
TASCAM X-15