Measuring Mode; Quickstart Guide - Knick Stratos Pro A2 COND Serie Inicio Rápido

Measuring Mode

After the operating voltage has been connected, the analyzer auto-
matically goes to "Measuring" mode. To call the measuring mode from
another operating mode (e.g. Diagnostics, Service):
Hold meas key depressed (> 2 s).
Sensoface indicator
(sensor status)
Time (or fl ow)
Mode indicator
(measuring)
Hold meas key
depressed for calling
the measuring mode
(pressing once more
switches the display)
Depending on the confi guration, one of the following displays can be
set as standard display for the measuring mode (see page 6):
• Measured value, time and temperature (default setting)
• Measured value and selection of parameter set A/B or fl ow
Measured value and tag number ("TAG")
• Time and date
• Output currents
• Controller (4-wire devices only)
Upper display: controller output Y, lower display: setpoint
Note: By pressing the meas key in measuring mode you can view the
displays for approx. 60 sec.
You must confi gure the device for the respective measurement
task!
Quickstart
Active
parameter set
(confi guration)
Display indicates
OUT1: e.g.
process variable
Display indicates
OUT2: e.g.
temperature
enter key
3