BEFORE USE
1. Before using this product, read the owner's manual completely and familiarize yourself thoroughly with the
product and the hazards associated with its improper use.
2. Check and that the product operates smoothly before putting into service.
3. Inspect before each use. Do not use if bent, broken or cracked components are noted.
MAINTENANCE INSTRUCTIONS
If you use and maintain your equipment properly, it will give you many years of service. Follow the
maintenance instructions carefully to keep your equipment in good working condition. Never perform any
maintenance on the equipment while it is under a load.
Inspection
You should inspect the product for damage, wear, broken or missing parts (e.g.: pins) and that all components
function before each use. Follow lubrication and storage instructions for optimum product performance.
Binding
If the product binds while under a load, stop use immediately and repair faulty parts. After un-binding; clean,
lubricate and test that equipment is working properly. Rusty components, dirt, or worn parts can be causes of
binding Clean and lubricate the equipment as indicated in the lubrication section. Test the equipment without
a load. If the binding continues contact Customer Service.
Cleaning
If the moving parts of the equipment are obstructed, use cleaning solvent or another good de-greaser to clean
the equipment. Remove any existing rust, with a penetrating lubricant.
Lubrication
This equipment will not operate safely without proper lubrication. Using the equipment without proper
lubrication will result in poor performance and damage to the equipment. Some parts in this equipment are not
self-lubricating inspect the equipment before use and lubricate when necessary. After cleaning, lubricate the
equipment using light penetrating oil, lubricating spray.
• Use a good lubricant on all moving parts.
• For light duty use lubrication once a month.
• For heavy and constant use lubrication recommended every week.
• NEVER USE SANDPAPER OR ABRASIVE MATERIAL ON THESE SURFACES!
Rust Prevention:
Check cylinders assemblies daily for any signs of rust or corrosion.
Without a load on the equipment raise cylinder as high as it will go and look under and behind the lifting
points. If signs of rust are visible clean as needed.
Storing the Product
1. Store in a dry location, recommended indoors.
Note: If the product is stored outdoors, be sure to lubricate all moving parts before and after use to ensure the
product stays in good working condition.
6