Object Temperature Measurements; Data Memory; Battery Replacement - Gima YI-400 Guía De Uso

11
Notice: When surrounding temperature is lower than 10.0°C or higher
than 40.0°C, it's not allowed to measure of accuracy in not assured.

Object Temperature Measurements

• Press the trigger to switch the meter on with one beeper. The device performs
a brief self test: all elements of the display are shown for approx. 1 second.
Following a successful self test with backlit(Red-Orange-Green).
• Press the "1 B/O" button for "Object temp" for wide range surface
measurements of most materials.
• Hold the meter by its handle and point it toward the surface to be measured.
• Press the trigger to take a temperature reading. The temperature reading
appears in the display.
• Release the trigger and the reading will hold for approximately 20 seconds
after which themeter will automatically shut off.
Note: Before shutting off,you can take further measurements.
• If the temperature goes above 212°F or 100°C, "Hi" will appear in the display.
If the temperature goes below 32°F or 0°C, "Lo" will appear in the display.
Notice:
• The value under this Mode is object temperature instead of core temperature.
• The defaulted infrared from the real temperature according to different
emissivity. For example,the reading on stainless steel will be obviously lower
than the actual temperature. BE CAUTIONS FOR SCALDING.

Data memory

• To review the logged data points,press the "3 Memory" button for one second
while the units is ON until "M" symbol shown on the display.Use the + or -
buttons to scroll through the stored measurements and memory locations.
Notice:
Under "1 B/O" switch for "Body temp" Mode,the body temperature memories
display;
Under "1 B/O" switch for "Object temp" Mode,the object temperature memo-
ries display;

Battery Replacement

• When the low battery symbol appears in the display, replace the meter's
battery. The battery compartment is located on the bottom of the handle.
Press down on the battery compartment lock and at the same time slide the
battery compartment downwards. Replace the (2) "AA" batteries and close
the battery compartment cover.
You, as the end user, are legally bound (Battery ordinance) to return all used
batteries and accumulators; disposal in the household garbage is prohibited!
You can hand over your used batteries / accumulators at collection points
in your community or wherever batteries / accumulators are sold!
ENGLISH