Use; Prudence; Hand Control - Wallmek HPB Manual De Instrucciones

furnished in endowment. In the model HPB RC unscrew with screwdriver the screw that it is on the oil plug and leave
free the hole for the air vent. Check the oil level using a special rod (no supplied in endowment).

8. USE

8.1 PRUDENCE!!!

To avoid damaging the pump and the cylinder to it connected not insist to pump when the cylinder -stem is to end run.
It is advised not to bring stem to the end run but to stop it with slight advance.
The pump employment in all versions is very simple:
8.2 EMPLOYMENT OF THE PEDAL.

Put in operate the pump pressing with the foot, without do an excessive pressure, in the zone pointed out by letter A.
The pump will begin to produce hydraulic pressure having the driving of the destination employment through output
of oil in the hydro-pneumatic circuit.

Leaving the pedal and removing the foot, the pump will stop its cycle and will remain in pressure, leaving the
employment of destination hold where it arrived .

To come back the employment to rest, bring the pressure to zero, pressing the pedal in the zone indicated by the
letter B. The oil will come back in the tank emptying the hydro-pneumatic circuit.
8.3 EMPLOYMENT OF THE HAND CONTROL

Put in operate the pump pressing with the foot, without do an excessive pressure, in the zone pointed out by letter A.
The pump will begin to produce hydraulic pressure having the driving of the destination employment through output
of oil in the hydro-pneumatic circuit.

Stopping the working of the handlever the pump will stop its cycle and will remain under pression

Pressing on the lever indicated with the letter "B" is removed the pressure from the hydraulic circuit
14