Pfister KENZO 16 Serie Manual De Instrucciones página 3

Ocultar thumbs Ver también para KENZO 16 Serie:
Idiomas disponibles

Idiomas disponibles

7
7 TRIM FLANGE ATTACHMENT
Position Flange (7A) onto Valve (7B). Place Protective Washer (7C) on the short end
of the reversible Retainer Sleeve (7D). Screw Retainer Sleeve (7D) onto threaded
section of Valve (7B). Tighten Retainer Sleeve (7D) by hand until Flange (7A) is snug to
finished wall surface. If the short end of the Retainer Sleeve (7D) is too short, reverse
it to use the longer end.
8
8 HANDLE ATTACHMENT
Thread Set Screw (8C) into Handle (8D) and thread it in only three to four turns. Place
Handle (8D) onto the SValve Stem (8B) and tighten Set Screw (8C) by using the Hex
Wrench (8E) that is provided.
Make sure Set Screw (8C) is securely tightened to Handle (8D).
9
9B
9A
3/4"
9 HOLE LOCATIONS FOR WALL MOUNT
Remove Front Cover (9A) from Wall Mount (9B). Use Wall Mount Screw Holes (9C) to
place the desired location. Using a punch or awl, tap the screw hole locations. Holes
must be vertically aligned.
7B
7A
7C
7D
8B
8D
8C
8E
9B
9C
ENGLISH
10
10A
10 ANCHOR INSTALLATION
1
Drill two
/
" Dia. Holes (10A). If installing into a stud, drill two
4
not use Anchors (10B). Insert Anchors (10B) into Holes (10A) and tap flush with wall.
11
11C
11 WALL MOUNT INSTALLATION
Place Wall Mount (11A) onto wall and insert Mounting Screws (11B) through Wall Mount
Holes (11C) and tighten until Wall Mount (11A) is flush with the wall. Do Not Over
Tighten! Insert Front Cover (11D) into Wall Mount (11A).
12
1 / 4 "- 3 / 8 "
12 DROP ELBOW & HOSE INSTALLATION
Apply PTFE plumbers tape on both ends of Pipe Niple (12A) (not included). Screw Pipe
Niple (12A) into the elbow inside the wall. The Pipe Niple (12A) is to project
from the finished wall. Screw Drop Elbow (12B) onto Pipe Niple (12A) and tighten until
Drop Elbow (12B) is properly positioned and flush to the finished wall.
Place Rubber Seal (12C) inside Hex Hose Fitting (12D). Connect Hex Hose Fitting (12D)
into Drop Elbow Outlet (12E) by turning Hex Hose Fitting (12D).
3
1
/
11C
11A
11B
12A
12E
12D
10B
" Dia. holes and do
8
11B
11D
12B
12C
1
3
"-
"
/
/
4
8
loading

Este manual también es adecuado para:

Kenzo g16 serie