Connecting External Devices - Gemini WRX-843 Manual Del Usuario

4
ENGLISH //
DESCRIPTION
The Gemini WRX-843 Modular Line-Array
Speaker System is an easily transportable
speaker system comprised of (6) 2.75" glass
fiber high-frequency drivers, an 8" high-
excursion low frequency driver, and dual
integrated amplifiers. This easy-to-use system
is highly portable and produces incredible
high-fidelity sound with the kind of dispersion
only possible with an array. Perfect for artists,
entertainers, or DJs, the WRX-843 delivers
pro PA performance in large or small venues
alike. With additional features like integrated
DSP, reverb effect, and Bluetooth streaming
support, it's the ultimate entertainment
solution for any gathering.
ASSEMBLY
A. Subwoofer with integrated electronics for
all system components.
B./C. Two identical spacers with connectors
on bottom and top.
D. Column element with the speakers and a
connection on the bottom.
Once the subwoofer is placed in the desired
location, plug the spacers into the subwoofer
and then add the column element with the
speakers. Depending on the application,
the column element with the speakers can
be opened with only one spacer on the
subwoofer.
WRX-843 MODULAR LINE-ARRAY
SPEAKER SYSTEM
CHANGING THE AC VOLTAGE
To change the operational
voltage on the WRX-843,
first power the unit OFF
and disconnect power and signal lines, then
move the clear switch cover to access the
red AC Voltage Switch. Finally, move the
switch left or right to select the correct voltage
for your area.
POWERING ON
Make sure the WRX-843 is fully assembled,
any required inputs and outputs are
connected, and mains power is connected.
Turn all volumes down, then switch power ON.

CONNECTING EXTERNAL DEVICES

Before connecting an input device to the
WRX-843, please make sure all input volumes
and the master volume are turned down.
WIRED MICROPHONES
Locate mixer channels 1 and
2 on the rear panel of the
unit. Both channels have a
"Combo Jack", allowing you
to connect either an XLR
or 6.5mm TRS cable to the
input. Switch the channel to
MIC level and connect your
microphone.
Note: The WRX-843 does not
supply phantom power.
BALANCED LINE LEVEL
SOURCE
Mixer channels 1 and 2 on
the rear panel of the unit are
used to connect balanced
line sources as well as
microphones. Switch the
channel to LINE level and
connect your device. This
type of connection would
typically be used to connect
professional gear like mixers or
electronic instruments.
AUX INPUT
Locate mixer channel 3/4 and find at
the bottom a 3.5mm TRS Jack. This
type of connection is commonly used
to connect the unit to the headphones
output of a mobile device.