Shoulder Harness Assembly; Fuelling The Machine; Starting The Machine - Trueshopping MFS260C Manual Del Usuario

Shoulder harness assembly

The shoulder harness attaches to the clip on
the main handle as shown above.

Fuelling the machine

PLEASE ENSURE THAT A 25/1
FUEL/OIL MIX IS USED
! Switch the engine off and ensure that it is
cool before fuelling.
! The use of unleaded petrol is recommended
! Only use two stroke engine oil for air-cooled
machines
•
Mix the fuel/oil together at a ratio
of 25/1 in the provided mixing
bottle.
! The mixing bottle is not designed
to be used for fuel storage
•
Open the fuel tank cap carefully to
ensure any overpressure may be
released without spilling fuel.
•
Fill the tank with fuel
! Any spillages should be removed
before attempting to use the
machine
•
Replace the fuel cap ensuring a
tight seal is maintained.
After fuelling ensure that the cap is tight and
will not be worked loose by machine vibrations
during operation.
! If you notice any leaking fuel, discontinue
use immediately and contact the supplier

Starting the machine

! Please be aware that a certain degree of
effort is required to successfully start the
multi-tool, please persevere if you are
struggling to start the engine.
•
Pull the switch into the on "I" position and
hold the throttle lockout and then pull the
throttle trigger.
•
While still holding the above, press in the
switch next to the on/off switch.
•
Slowly release all three and you should
note that the switch stays pressed in.
10