jbc DM 6700 Manual De Instrucciones página 7

OPERATION
Use of keys
Increases and decreases the
temperature.
See the selected temperature.
PROGRAMMING
The system allows you to modify and adjust the
temperature between 90 and 450ºC (190 and
840ºF). These are the factory pre-selected
temperatures:
- Minimum temperature: 90ºC
- Maximum temperature: 400ºC
In order to modify the station and tool parameters
and have access to the counters, you must hold
the SELECT key for 3 seconds. The PIN number
must be entered when you need to change a
station parameter. Default PIN number: 0105.
When you need a specific tool take it out of the
support leaving the other tools in their supports.
You will find the operation diagrams are on the
following pages.
Display messages
- HIB: The station is in hibernation mode.
- E.OC: "Open circuit". Heating element with open
circuit. Possible causes:
The cartridge has not been inserted correctly
in the tool.
Damaged cartridge.
- E.MP: "Maximum power". The maximum
available power has been exceeded for too
long - e.g. in very thick and repetitive soldering
jobs.
- E.SC: "Short circuit". Short circuit in the system.
- E.TL: "Tool". Tool error.
Possible causes: use of a tool which is not
compatible with the station for example the
solder feed iron.
- E.HT: "Hot". To prevent overheating and
damaging the station circuit, you must wait till
the temperature of the circuit goes down and
the station will automatically be ready to work.
Possible causes: very thick and repetitive
soldering jobs.
Once you correct the above mentioned causes,
the station will start working automatically, except
if there is an excess in energy supply (E.MP). In
this case, the station has to be switched off and
restarted.
5
ENGLISH