Daily Operation - Maytronics Dolphin COMM. 12 Instrucciones Para El Usuario

6. DAILY OPERATION

To operate the Robotic Pool Cleaner:
1. Place the robot in the pool. Press the ON button on the power supply. The cleaning session will
begin according to the chosen cycle time.
2. At the end of the cycle time press the OFF button on the power supply.
3. Holding the floating cable, gently pull the robot upwards and towards the Caddy. As it reaches the
side of the pool, pull the cable gently until the handle emerges. Grasp the handle (not the cable),
and pull the robot out of the water.
You can use the remote control unit to drive the Robotic Pool Cleaner to the pool side where the
Caddy is located, then gently pull the cable as described above.
Make sure the floating cable is not tangled, so it can be rolled up easily and placed on the Caddy's
handle.
4. Clean the filter as needed. Before the next operating cycle, you should also clean the robot body,
brushes and driving belt area, and remove foreign objects like rubber bands and hair, etc.
5. Once a week clean the impeller area:
Make sure the power supply is switched off and unplugged before service.
CAUTION
• Remove the four screws securing the cover of the impellers using a No. 2 Philips manual
screwdriver.
• Open and remove the cover of the impellers.
• Remove foreign objects from the impellers.
• Close the cover and re-secure the four screws.
COMM. 12 Robotic Pool Cleaner User Instructions
|
5