Xerox WorkCentre 7232 Guida Rapida
Ocultar thumbs Ver también para WorkCentre 7232:
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 17

Enlaces rápidos

Quick Network Setup Guide
This guide includes instructions for:
Quick Network Setup (DHCP)
Quick Network Setup (Static IP)
Note
For more detailed instructions, see the System Administrator Guide.
Quick Network Setup (DHCP)
The System Administrator Guide contains detailed information about network setups. This
document is intended for setting up the network using TCP/IP. If using Novel IPX, see the
System Administrator Guide for setup procedures.
Prerequisites for Quick Network Setup Using TCP/IP
1.
Confirm that an existing operational network utilizing TCP/IP is available.
2.
Confirm that the Ethernet cable is plugged into the multifunction device and into an
operational Ethernet port on the network.
Note
The Ethernet cable is an RJ45 type and is not supplied by Xerox.
Configuring an IP Address via DHCP
On startup, the multifunction device defaults to DHCP to obtain its network configurations.
A DHCP server delivers an IP address, as well as other configuration settings to the device. If
you use a DHCP server to allocate an IP address to the device, then proceed as follows:
Procedure for Quick Network Setup Using TCP/IP
1.
Power on the device.
2.
Wait 3 to 5 minutes while the device negotiates an IP address.
3.
Print the Configuration Report:
a.
Press the
b.
Select the Billing Information tab.
c.
Touch Print Reports.
d.
Touch Copy Reports.
e.
Touch Configuration Report.
f.
Press the
Copyright © 2007, Xerox Corporation. All rights reserved.
on page 1
on page 3
Machine Status
button on the device.
Start
button, then touch Close.
Xerox WorkCentre
1
®
7232/7242
701P46477
v1 .0
Tabla de contenido
loading

Resumen de contenidos para Xerox WorkCentre 7232

  • Página 17: Configuración Rápida En Red (Dhcp)

    Ethernet que esté en servicio en la red. Nota El cable Ethernet es del tipo RJ45 y no lo suministra Xerox. Configuración de una dirección IP mediante DHCP Al encenderse, el dispositivo multifunción activa automáticamente DHCP para obtener la configuración de red.
  • Página 18 Instale los controladores de impresión en las estaciones de trabajo que vayan a tener acceso al dispositivo. © Xerox Corporation, 2007. Reservados todos los derechos.
  • Página 19: Configuración Rápida En Red (Ip Estática)

    IP del dispositivo). Si el dispositivo está disponible, debería aparecer la página web de Servicios de Internet de CentreWare del dispositivo. Instale los controladores de impresión en las estaciones de trabajo que vayan a tener acceso al dispositivo. © Xerox Corporation, 2007. Reservados todos los derechos.
  • Página 20 Configuración rápida en red (IP estática) Esta página se ha dejado en blanco intencionadamente. © Xerox Corporation, 2007. Reservados todos los derechos.

Este manual también es adecuado para:

Workcentre 7242

Tabla de contenido