Pc Input Terminals Connection - Sanyo PID-42NE1 Instrucciones De Instalación

PC Input Terminals connection

COMPUTER
Notes:
• Computer signals which can be input are those with a horizontal scanning frequency of 30 to 110 kHz and vertical scanning
frequency of 48 to 120 Hz. (However, the image will not be displayed properly if the signals exceed 1,200 lines.)
• The display resolution is a maximum of 1,440 × 1,080 dots when the aspect mode is set to "4:3", and 1,920 × 1,080
dots when the aspect mode is set to "16:9". If the display resolution exceeds these maximums, it may not be possible
to show fine detail with sufficient clarity.
• The PC input terminals are DDC2B-compatible. If the computer being connected is not DDC2B-compatible, you will
need to make setting changes to the computer at the time of connection.
• Some PC models cannot be connected to the set.
• There is no need to use an adapter for computers with DOS/V compatible Mini D-sub 15P terminal.
• The computer shown in the illustration is for example purposes only.
• Additional equipment and cables shown are not supplied with this set.
• Sanyo recommends using a PC cable that includes a Ferrite core.
• Do not set the horizontal and vertical scanning frequencies for PC signals which are above or below the specified
frequency range.
• Component Input is possible with the pin 1, 2, 3 of the Mini D-sub 15P Connector.
• To use sync input VBS signals, use the connector which incorporates a 75-ohm termination resistance and which is
available on the market, for the connection of the HD connector where the VBS signals are to be input.
Signal Names for Mini D-sub 15P Connector
5 4 3 2 1
10 9 8 7 6
15 14 13 12 11
Pin Layout for PC Input
Terminal
Audio
Connect a cable which matches
the audio output terminal on the computer.
Conversion adapter
(if necessary)
Pin No. Signal Name
R
1
G
2
B
3
NC (not connected)
4
GND (Ground)
5
Shared with DVI-D IN.
Stereo mini plug (M3)
Mini D-sub 15p
RGB
PC cable with
(Male)
Ferrite core
Pin No. Signal Name
GND (Ground)
6
GND (Ground)
7
GND (Ground)
8
+5 V DC
9
GND (Ground)
10
Connections
(Female)
Pin No. Signal Name
NC (not connected)
11
SDA
12
HD/SYNC
13
VD
14
SCL
15
11