Getting Your Ice Maker Ready For Use; Unpacking Your Ice Maker; Electrical Shock Hazards - THINK GIZMOS TG20 Manual De Usuario

4. GETTING YOUR ICE MAKER READY FOR USE

4.1 Unpacking Your Ice Maker

1. Remove the Ice Maker from the box. Throw away the plastic bag. Do not throw away the
box as this may be required for future storage.
2. Check all the parts are included. There should be 3 parts in total: Ice Maker, Ice Basket
and Ice Scoop.
3. Remove all the tape in the unit.
4. Use lukewarm water and a soft cloth to clean the interior of the Ice Maker, the ice basket
and the ice scoop.
5. Find a location for your ice maker that is protected from direct sunlight and other
sources of heat (i.e.: stove, furnace, radiator). Place the ice maker on a level surface.
Make sure that there is at least 4 inches of space between the back and sides of your ice
maker and the wall.
6. Allow one hour for the refrigerant fluid to settle before plugging ice maker in.
7. The appliance must be positioned so that the plug is accessible.

4.2 Electrical Shock Hazards

This unit should be properly grounded for your safety. The power cord of this appliance is
equipped with a three-prong plug which mates with standard three prong wall outlets to
Plug your appliance into an exclusive, properly installed, grounded wall outlet. Do not
under any circumstances, cut or remove the third (ground) prong from the power cord.
Any questions concerning power and/or grounding should be directed toward a certified
This appliance requires a standard 220-240volt, 50Hz electrical outlet with three-prong
WARNING
Electrical Shock Hazard
Plug Into a grounded outlet.
Do not use an extension cord.
Failure to follow these instructions can result in
death, fire, or electrical shock.
minimize the possibility of electric shock.
electrician.
ground.
7