Diode Test; Hold Function; Setting Up The Multimeter - Powerfix Profi PDM 300 B1 Manual De Instrucciones

7.9 Diode test

Ensure that all circuit elements, circuits and components to be measured and other test objects
are completely switched off and discharged. Otherwise, the multimeter could be damaged.
 Connect the black test lead to the COM jack [4] and the red test lead to the Ω V mA
 Set the range selector switch [3] to the
 Connect the red test probe [6] to the anode and the black test probe [6] to the cathode of the diode
to be tested.
 The forward voltage is indicated in volts on the display [1]. If "1" is displayed on the display [1], the
diode is measured in the reverse biased-direction or the diode is defective. Perform an opposite pole
measurement for check purposes.

7.10 HOLD function

A measured value on the display [1] can be saved by pressing the HOLD button [2]. Press the HOLD
button [2] again to return to the measuring mode.

7.11 Setting up the multimeter

You can set up the multimeter. Open out
the stand at the back of the multimeter to
set up the multimeter.
position in the Ω measuring range.
POWERFIX PDM 300 B1
jack [5].
English - 59