Cleaning And Maintenance - UFESA HA7000 Manual De Instrucciones

4
Fill the kettle with the desired amount of water (the
level is visible on the indicator (3)).
Do not boil the water if it is below the
minimum level or beyond the maximum
level on the indicator (3).
5
Close the lid (5).
6
Plug the kettle to a socket provided with an earth pin.
7
Turn the kettle on by switching the on/off switch to
position I — the power indicator lights.
8
Once the water is boiling, the kettle will
automatically turn off and the switch returns to off
position — the power indicator goes off.
Wait a few seconds before boiling water again.
Always unplug the kettle after use.
In the event that an empty kettle is
switched on, it will be switched off
automatically by a thermal device.
To use the kettle again once it has cooled down,
pour water and turn on the kettle by pressing
the on/off switch (6). The cooling down of the
kettle can be accelerated by pouring cold water
into the kettle.

Cleaning and maintenance

Always allow the kettle to cool down
completely before cleaning!
1
Unplug the kettle from the mains.
2
Remove the filter (10) and rinse it under running water.
3
Clean the outside surfaces with a soft damp cloth
and washing-up liquid.
In order to remove the build-up of hard water film from
the outside and inside walls of the kettle, wipe them
with a damp cloth and vinegar.
4
Rinse the kettle with fresh water.
Various black-coloured, rusty, milky, etc.
deposits may form inside the kettle and
float on the water. This is caused by
minerals occurring naturally in water (calcium,
magnesium, iron, etc.). Such discoloration is not
caused by faulty operation of the appliance and
does not affect its use. In case of substantial
accumulation of mineral deposits, proceed as
described in the "Descaling" section.
Descaling
In the event that scale builds up on the bottom of the
kettle, it needs to be removed. For this purpose use
6-10% vinegar or citric acid.
● Open the kettle lid.
● Add 0.2 l of vinegar or 40 g of citric acid and fill the
kettle with water up to the maximum level. Switch on
the kettle.
● Bring the mixture to boil and allow the kettle to stand
for 30 minutes.
● Empty the kettle and rinse it with fresh water.
● Remove the filter (10) and rinse it under running water.
Replace the filter.
● Fill the kettle with fresh water, boil the water and
empty the kettle.
● If sediment is still visible in the kettle, remove it with
a sponge and rinse the kettle again. If unsuccessful,
repeat the descaling process.
The kettle should be descaled
periodically to avoid its possible damage.
C
Disposal
Dispose of packaging in an environmentally-friendly
manner. Our goods come in optimised packaging.
This basically consists in using non-contaminating
materials which should be handed over to the local
waste disposal service as secondary raw materials.
This appliance is labelled in accordance with
European Directive 2012/19/EU concerning
used electrical and electronic appliances
(waste electrical and electronic equipment
– WEEE). The guideline determines the framework for
the return and recycling of used appliances as applicable
throughout the EU. Please ask your specialist retailer
about current disposal facilities.
The manufacturer does not accept any liability for any damages
resulting from unintended use or inappropriate handling.
The manufacturer reserves his right to modify the product any
time in order to adjust it to the law, standards, directives, or due to
construction, trade, aesthetic or other reasons, without prior notice.