Installation Instructions; Recommended Tools - Glacier bay UHET 0.8 GPF Instrucciones De Instalación

Installation Instructions

Vitreous china plumbing products are heavy and fragile. To avoid injury or damage, ask for assistance and handle
with extreme care.
You have purchased the best gravity-flush, 0.8 gallon (3 Liters) flush toilet. To insure proper installation carefully read
these instructions and be sure you have the proper tools to complete the job.
When installing a 0.8 gallon (3 Liters) per flush toilet, make sure the plumbing system is vented adequately and that
the soil pipe is clean.
Be very cautious when working with vitreous china plumbing products. Vitreous china can break and chip if you
overtighten mounting bolts or nuts. Such breaks and chips are as sharp as glass and should be handled with care.
Take care when handling these products.

Recommended Tools:

• ½" x 9/16" box or open-end wrench
• Adjustable wrench
• Caulking
• Hacksaw
TO START, TURN OFF THE MAIN WATER SUPPLY.
1.
2.
3.
• Level
• Putty knife
• Screwdriver
• Tape measure
Install new "T" bolts with elongated brass flat washers and
thin brass hex-head (jam) nuts
Remove the toilet from the box and set the toilet upside down
on a soft surface. (You may use the box for this purpose.) Set
the wax ring firmly in place around the outlet of the toilet.
Carefully lower the toilet bowl onto the floor flange while
aligning the "T" bolts through the two holes in the toilet bowl
foot.